Fortinet 2 SXRC manual Press the ENT key to enter your lock code, Again

Operation

Use the ESC and ENT keys to move the
blinking cursor left or right to select which
character you want to change.	ESC	HOME ENT

Use the UP and DOWN keys to change the selected character. (A B C ...1 2 3 ...etc.)

If you have tried entering your code several times with no success (several is defined as more than 3...less than 10) then you probably have forgotten your lock code.

You will need to call KICKER directly at (405) 624-8583 and speak to a tech to handle this situation. You will need to have your amplifier’s serial number AND your receipt by the phone as

When you are finished press and hold the HOME key for 1.5 seconds to enter your unlock code.

ESC HOME ENT

PRESS &

HOLD

ESC HOME ENT

the guys and gals answering the phone will need this information from you to be of assistance.

Take the time right now to fill out the first page in this manual and staple your receipt to it. That way if you ever need service (like forgetting your lock code) you will have all the information

If the code is correct the SXRC will unlock and return to the

MAIN menu. If this did not happen, then read on...

If you enter the wrong code the display will flash the message BAD CODE and return you to the UNLOCK menu.

AMP1 AMP2

LOCK LEFT SYS RIGHT MUTE

GAIN EQ LPF HPF PHASE KOMP

baad	coodde
MEM-1 MEM-2	MEM-3	MEM-4
AMP1		AMP2
LOCK LEFT SYS RIGHT MUTE
GAIN EQ LPF HPF PHASE KOMP
u nlloocck
MEM-1 MEM-2 MEM-3		MEM-4
Press the ENT key to enter your lock code			ESC HOME ENT
again.

Enter your code again making sure to place the correct character in the correct position in the display. Blank spaces count as part of the code so be sure you are entering your code correctly.

you need right here with the manual.

NOTE:

The local ISIS keypads on all SX Series amplifiers are disabled once connected to the SXRC, their display will scroll SXRC CTRL to indicate this. If you disconnect the SXRC Control Head and power up the system, the local keypad at each amplifier will become active again. The LOCK AMPS menu

item on the SXRC prevents the use of the amplifier’s local keypad when the SXRC Control Head is disconnected ... unless you know the lock code.

If LOCK AMPS is activated, the LOCK indicator on all connected SX Series amplifiers will be turned on. If you use UNLOCK, the indicators will be turned off.

76 SXRC Remote Control