Fortinet 2 SXRC manual 87654321

Now insert the removable power plug into the SXRC Interface Box.

NOTE!!!

There are 8 pins in each RJ45 jack used on the SXRC Interface Box and on SX Series amplifiers. We only use 3 of these pins for the Digital Communications Network: Pins #2, #7 and #8.

	RJ45 Communication
Interface Box	Network Jack
SXRC TO

Power, Ground

Remote Jack

87654321

Installation

FROM AMP

+ 12V REM GND

HyperFlex Ground

HyperFlex Remote

HyperFlex 5 +12 Volt

Fuse

1 2 3 4 5 6 7 8

SX Amplifiers SXRC

You should have something resembling this picture at this point. The Control Head plugged in and the power plug wired correctly and plugged in.

If pins #2, #7 or #8 are bent or damaged, you will not be able to establish reliable communications on the SXRC Digital Communications Network.

AMP1 AMP2

LOCK LEFT SYS RIGHT MUTE

GAIN EQ LPF HPF PHASE KOMP

*	kicker *			ESC	HOME ENT
MEM-1	MEM-2	MEM-3 MEM-4
M1	M2	M3	M4

Control Head

SXRC TO

Interface Box

FROM AMP + 12V REM GND

HyperFlex Ground

HyperFlex Remote

HyperFlex 5 +12 Volt

Fuse

A common issue is if your SX Series amplifier has been used with the Remote Bass Level Controller prior to being used with the SXRC. Some cables that came with the SX Series amplifiers for use with the Remote Bass level Controller will bend pins #1 and #8 down too far causing poor contact with the SXRC Communications Network Cable. To fix this simply take a small screwdriver or paper-clip and pull these pins back up into place.

Check all the RJ45 jacks on your amplifiers to insure the pins are up and in place before plugging in any of your SXRC Communications Network Cables.

SXRC Remote Control 13