5-Meter Network Cable
AMP STRAPPING
IN OUT
1-Meter Network Cable
AMP STRAPPING
IN OUT
1-Meter Network Cable
AMP STRAPPING
IN OUT

Installation

Software Updates

Now that you have the SXRC mounted and wired properly it is time to update the software in all of your SX Series amplifiers. This process has to be completed for EACH amplifier and does

require you to disconnect

 

 

 

Communication

 

 

Interface Box Network Jack (RJ45)

 

 

and reconnect cables

 

 

SXRC TO

 

 

 

 

 

 

 

 

Power, Ground

 

between each step.

 

 

 

 

 

 

 

Remote Jack

 

Please read the

 

 

 

 

 

+ 12

V M

ND

 

 

FROM AMP

RE G

 

Ground

 

instructions and follow

 

 

 

HyperFlex

 

 

 

 

HyperFlex

Remote

 

 

 

 

them exactly as

 

 

 

HyperFlex

5

+12 Volt

 

 

 

 

 

 

 

 

 

Fuse

 

described.

NOTE!!!

Each SX Series amplifier must be assigned its own unique address from the amplifier’s keypad before it can be updated and controlled by the SXRC. This has to be done at each amplifier’s keypad and can not be done from the SXRC. Think of the amplifiers like houses...no two houses can share the same street address...the mailman would throw a complete fit! Well, the SXRC feels the same way about two amps sharing the same Remote Communication Address.

Each series of SX amplifiers (.2-Stereo, .1-Mono Block, .4-Four Channel) has a unique address range that is not shared between the others. So it is impossible to accidentally share addresses

You only have to do this setup and programming process one time for each amplifier.

Step 1.) Un-plug the Communications Network Cables from the REMOTE OUT jacks on ALL the SX Series amplifiers. Leave the Communications Network Cables connected to the REMOTE IN jacks. The SXRC Interface Box should only be connected to the first SX Series amplifier as the diagram to the right is showing.

IN OUT

IN OUT

IN OUT

Additional Network Cable

(Supplied By You)

from one series with another. All you need to do is assign a unique (different) address to each amplifier in you system. The possible choices for each series are:

SX.2 Series - Addresses 10-59

SX.1 Series - Addresses 60-109

SX.4 Series - Addresses 110-119

All SX Series amplifiers are shipped from the factory with their Remote Address set to the lowest setting.

SX.2 Series - Address 10

SX.1 Series - Address 60

SX.4 Series - Address 110

For example, lets say you have 4 SX.2, 4 SX.4 and 4 SX.1 amplifiers in your system for a grand total of 16 amplifiers. Set the Remote Addresses as such:

SX.2 # 1

- 10

SX.1 # 1 - 60

SX.4 # 1

- 110

SX.2 # 2

- 11

SX.1 # 2 - 61

SX.4 # 2

- 111

SX.2 # 3

- 12

SX.1 # 3 - 62

SX.4 # 3

- 112

SX.2 # 4

- 13

SX.1 # 4 - 63

SX.4 # 4

- 113

To Next Amplifier

16

SXRC Remote Control

Page 16
Image 16
Fortinet 2 SXRC manual Reconnect cables, Between each step, Please read, Instructions and follow, Them exactly as