![](/images/new-backgrounds/1169983/169983389x1.webp)
Management Commands |
| Command Reference |
Enabled
Command Mode
Global Config
7.5.5SNMP Trap Commands
7.5.5.1show snmptrap
This command displays SNMP trap receivers. Trap messages are sent across a network to an SNMP Network Manager. These messages alert the manager to events occurring within the IBP or on the network. Six trap receivers are simultaneously supported.
Syntax |
show snmptrap |
Default Setting
None
Command Mode
Privileged Exec
Display Message
SNMP Trap Name: The community string of the SNMP trap packet sent to the trap manager. This may be up to 16 alphanumeric characters. This string is case sensitive.
IP Address: The IP address to receive SNMP traps from this device. Enter 4 numbers between 0 and 255 separated by periods.
SNMP Version: The trap version to be used by the receiver. SNMP v1 – Uses SNMP v1 to send traps to the receiver SNMP v2 – Uses SNMP v2 to send traps to the receiver
Status: A pull down menu that indicates the receiver's status (enabled or disabled) and allows the administrator/user to perform actions on this user entry:
Enable: send traps to the receiver
Disable: do not send traps to the receiver.
Delete: remove the table entry.
194 | Intelligent Blade Panel Module |
|