Fujitsu BX600 manual Tftp

Software Download Configuration the IBP Module

file name	file type	startup		size (byte)
--------------------------------	-------------- ------- -----------
PRIMERGY BX600-b-0.4.1214.biz Boot-Rom image					Y	118206
default.cfg	Config File		Y		17336
PRIMERGY BX600-r-c-0.5.0110.biz Operation			Code		Y	40666365

5.Enter (vty-0) # copy tftp://{tftp address}/{file name} image {file name} command to copy a new system image to the device. The following message is displayed:

Mode	TFTP
Set TFTP Server IP	{tftp address}
TFTP Path	./
TFTP Filename	{file name}
Data Type	Code
Are you sure you want to start? (y/n)

6.Press Y. When the new image is downloaded, it is saved in the area allocated for the other copy of system image. The following is an example of the information that appears:

TFTP code transfer starting

Verifying CRC of file in Flash File System

TFTP receive complete... storing in Flash File System...

File transfer operation completed successfully.

7.Select the image for the next boot by entering the boot-systemcommand. After this command. Enter (vty-0) # whichboot command to verify that the copy indicated as a parameter in the boot-systemcommand is selected for the next boot. The following is an example of the information that appears:

(vty-0) #boot-system opcode PRIMERGY BX600-r-q-0.50.0110.biz Start Up Success!

(vty-0) #

(vty-0) #whichboot
file name	file type startup size (byte)
--------------------------------	-------------- ------- -----------
PRIMERGY BX600-b-0.4.1214.biz Boot-Rom image			Y	118206
default.cfg	Config File	Y	17336
PRIMERGY BX600-r-q-0.5.0110.biz Operation Code			Y	4153628

If the image for the next boot is not selected by entering the boot system command, the system boots from the currently active image.

8. Enter the reload command. The following message is displayed:

41 Intelligent Blade Panel Module