Fujitsu BX600 Operation Code CLI Software Download Through Tftp Server, System Image Download

Software Download Configuration the IBP Module

8.Enter the reset command. The following message is displayed:

BootROM > reset

Are you sure you want to reset the system (y/n)? y

System Resetting...

9. Enter y. The device reboots.

5.6.2In Operation Code CLI

Software Download Through TFTP Server

This section contains instructions for downloading device software through a TFTP server. The TFTP server must be configured before beginning to download the software.

System Image Download

The device boots and runs when decompressing the system image from the flash memory area where a copy of the system image is stored. When a new image is downloaded, it is saved in the other area allocated for the other system image copy. On the next boot, the device will decompress and run the currently active system image unless chosen otherwise.

To download a system image through the TFTP server:

1.Ensure that an IP address is configured on one of the device ports and pings can be sent to a TFTP server.

2.Make sure that the file to be downloaded is saved on the TFTP server (the img file).

3.Enter (vty-0) # show version command to verify which software version is currently running on the device. The following is an example of the information that appears:

(vty-0) #show version
Unit1
Serial number	:123456789
Hardware Version	:1.0
Number of ports	:16
Label Revision Number	:123456789
Part Number	:123456789
Machine Model	:PRIMERGY BX600
Loader version	:1.0
Operation code version	:0.50
Boot rom version	:1.0

4.Enter (vty-0) # whichboot command to verify which system image is currently active. The following is an example of the information that appears:

(vty-0) #whichboot

40 Intelligent Blade Panel Module