Fujitsu BX600 manual Accessing the Management Interface, Symptom Action

Accessing the Management Interface Troubleshooting and Tips

10.2 Accessing the Management Interface

You can access the management interface for the IBP from anywhere within the attached network using Telnet, a Web browser, or any SNMP-based network management software. If you are having trouble accessing the management interface, then refer to the troubleshooting information displayed in the following table.

Symptom			Action
Cannot connect to the			• Be sure you have configured the agent with a valid IP address,
IBP using Telnet, Web			subnet mask and default gateway.
browser,	or	SNMP	• If you are trying to connect to the agent via the IP address for a
software
			tagged VLAN group, your management station must include the
			appropriate tag in its transmitted frames.
			• Check that you have a valid network connection to the IBP
			and that the port you are using has not been disabled.
			• Check network cabling between the management station and the
			IBP.
			• If you cannot connect using Telnet, there may already be four
			active sessions. Try connecting again at a later time.
Cannot access		the	• Be sure you have set the terminal emulator program to VT100
on-board			compatible, 8 data bits, 1 stop bit, no parity, and 19200 bps.
configuration program
			• Check that the null-modem serial cable conforms to the pin-out
via a	serial	port
			connections provided in the Operating Manual for the server.
connection
Forgot or	lost	the	• Restore the “Factory_Default_Config.cfg” file with the “boot
password			system” command described on page 134.

287 Intelligent Blade Panel Module