5.Install the Back-lamp unit in the reverse order of its removal. Make sure the connectors meet properly.

6.Close the side cover. Confirm that the cover is closed securely.7.Clear the Rear-side lamp counter.

Please refer to the section “7.3 Setup Mode Details”, “ 9. Abrasion counter (Abrasion CNT) reset ” on page 7-33.

You can check the cumulative lamp-on time from the Operator panel Test

HINTmode.

For the details, refer to the section "7.5 Test Mode Details", "3.Display the cumulative lamp-on time" on page 7-81.

4

CONSUMABLES OF REPLACEMENT

4.7 Replacing the Back-side Lamp 4-23