3)At <Screen 4-1> you can enable or disable the Double-feed detection or

configure the detection modes by pressing (Right arrow button) or (Left arrow button).

<Screen4-1>

!

0 4 -

1

U

l t r

a

s

o n

i

c

=

O f f

/

O n

-> 1 /

2

:

F u

l

l

By pressing (Right arrow button), the selection moves from (1) to (3).

By pressing (Left arrow button), the selection moves from (3) to (1).

(1)

[Off] is blinking:

Document overlapping is not checked.

(2)

[On] and [1] are blinking:

Document overlapping is checked for the

 

 

range set at step 4). This mode is used

for preventing mis-detection when scanning documents that are pasted photos, etc.

(3)[On] and [2: Full] are blinking: Document overlapping is checked for the whole area of the documents.(Default setting)

4)At <Screen 4-2> you can set the detection range for Double-feed by checking

document overlapping. Press (Left arrow button) or (Right arrow button) to set the start and end positions for the detection.

<Screen 4-2>

! 0

4

-

2

S U S

r a

n

g e

T o

p

:

 

0

L : 1 0

0

m m

(1)

[Top] is blinking:

The start position for the detection is set.

(2)

[L] is blinking:

The detection is range set.

Press (Next button) or (Previous button) to increase/decrease the value of

the selected item. To enable the settings, press (Enter button).

7.3 Setup Mode Details 7-21

7

MENUS PANEL OPERATOR