22.Setting Interface

1)Press (Next button) or (Previous button) and let LCD display <Screen22>.

<Screen22>

!

2 2

I

n

t

e

r f a

c

e

=

A u t

o

/

S

C S I

/

T P S

2)At <Screen22>, press (Left arrow button) or (Right arrow button), and select the type of interface.

The blinking item is the one selected.

HINT

Available interface settings are as follows:

(1)[Auto] is blinking: If an interface board, either from third party or optional, is installed in TPS, this interface is used. If not, SCSI interface is used.

(2)[SCSI] is blinking: SCSI interface is used. The interface on TPS is disre- garded.

(3)[TPS] is blinking: TPS interface is used. The SCSI interface is disre- garded.

By pressing (Left arrow button), selection moves from (3) to (1).

By pressing (Right arrow button), selection moves from (1) to (3).

3)Press (Enter button) to confirm the setting.

Press (Exit button) at the end and the LCD display goes back to [Ready] screen.

7

MENUS PANEL OPERATOR

7.3 Setup Mode Details 7-51