Guide Pin A
Guide Pin B
Position No. |
| A | Guide Pin B | |
|
|
| ||
| Guide Pin | |||
|
| (Large) |
| (Small) |
Assembling 38P connector
Positioning guide pins
Guide pins of the connector identify the mating receptacle.
They are;
•Guide pin A (Large): 4
•Guide pin B (Small): 1
Assembling BNC connector (CN-A304 to 308)
1.Remove vinyl sheath of the cable by 7.5 mm.
2.Pass the cable through the nut, washer, gasket and clamp.
3.Unravel the shield and fold it back onto the clamp.
4.Remove the insulator, leaving 3 mm.
5.Trim the shield as shown in the drawing. Solder the center chip to the conductor of the cable.
6.Pass the cable through the housing and tighten the nut.
Housing Clamp Washer Nut
Center Pin Gasket
7.5
Shield
3
