Furuno FSV-24S installation manual Control cable, Assembling D-SUB connector CN-A302

Assembling D-SUB connector (CN-A302)

1.Remove vinyl sheath of cores by 3 mm.

2.Pass the cores through shrink tubes (local supply).

3.Solder cores to connector pins referring to the schematic diagram at the back of this manual.

4.Assemble the connector.

Shrink tube

Cable clamp

Assembling D-sub connector

2.3.2Control cable

For FURUNO-supplied monitor, attach the cable from the control unit to the CN-A301 connector on the monitor unit as shown in the next section. For blackbox type, this cable should be connected to the CN-A103 connector in the processor unit.

2-6