Furuno FSV-84 manual Iii, Replace anticorrosion zinc plate yearly

SAFETY INSTRUCTIONS

CAUTION

Maximum speed while the transducer is projected and being raised or lowered is as below, to prevent damage to the transducer.

	Projected	Raising/
		Lowering
800 mm stroke	Max. 18 kt	Max. 15 kt
1100 mm stroke	Max. 18 kt	Max. 15 kt

Replace anticorrosion zinc plate yearly.

Corrosion between the main shaft and transducer may result if not replaced, allowing water leakage and/or loss of transducer.

CAUTION

Observe the following precautions when using industrial use lubricant.

Precautions

Keep lubricant away from eyes. Wear protective goggles when working with the lubricant.

The lubricant can cause inflammation of the eyes. Do not touch the lubricant. Wear protective gloves when working with the lubricant. The lubricant can cause inflammation of the skin.

Do not ingest the lubricant. Diarrhea and vomiting may result.

Keep the lubricant out of reach of children.

Emergency procedures

If the lubricant enters eyes, flush with clean water about 15 minutes. Consult a physician.

If the lubricant contacts skin, flush area with clean water.

If the lubricant is ingested, see a physician immediately.

Disposal of lubricant and its container

Dispose of the lubricant and its container in accord- ance with local regulations. If you are unclear about the disposal procedure, contact a FURUNO agent or dealer for advice.

WARNING LABELS

Warning labels are attached to the units of the system. Do not remove the labels.

If a label is missing or damaged, contact a FURUNO agent or dealer about replacement.

DANGER

Electrical shock hazard. Do not remove cover.

No user-serviceable parts inside. Turn off power before servicing. And wait until charge lamp (green) goes off and then remove cover.

DANGER

Keep fingers away from gears.

Shaft may cause injury. Keep away froom moving shaft.

Name: Warning Label

Type: 10-079-6144

Code No.: 100-310-880

WARNING

To avoid electrical shock, do not remove cover. No user-serviceable parts inside.

Name: Warning Label (1)

Type: 86-003-1011-1

Code No.: 100-236-231

Name: Warning Label

Type: 10-071-5313

Code No.: 100-291-160

WARNING

To avoid electrical shock, do not remove cover.

No user-serviceable parts inside.

Name: Warning Label (2)

Type: 03-129-1001-1

Code No.: 100-236-741

iii