About the controls on your Zoneline. | ge.com | |||
|
|
|
|
|
|
|
|
|
|
TEMP CONTROL | MODE CONTROL |
Controls
Safety Instructions
Operating InstructionsTemp Control
The temp control is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the same comfort level. When you turn the knob to COOLER (blue), the indoor air will become cooler. Turn the knob to WARMER (red) and the indoor air will become warmer.
3800 Series only
When the outdoor temperature is lower than 20°F, heat is provided by the electric heater in the air conditioner instead of by the heat pump.
Mode Control
HIGH COOL and LOW COOL provide cooling with different fan speeds.
HIGH HEAT and LOW HEAT provide heating with different fan speeds.
LOW FAN or HIGH FAN provides air circulation and filtering without cooling or heating.
NOTE: If you move the switch from a cool or heat setting to STOP or to a fan setting, the unit has an automatic
Care and Cleaning
Heat pumps can save money by removing heat from the outside
To get the best performance from your heat pump, don’t change the room thermostat very often. Raising the heat setting
There is a three minute minimum compressor run time at any setting to prevent short cycling.
The indoor fan motor starts before the compressor and stops after the compressor cycles off.
The electric heating elements use much more electricity than heat pumps and cost more to operate.
Troubleshooting Tips
Consumer Support3