Henny Penny OFE- 291 manual Filter Tracking Enabled Sp-8, Mixed

Model OFE- 291

3-16. SPECIAL PROGRAM	e. Change the idle setpoint temperature, by pressing
MODE (Continued)	f. Press and release	. “SP-7B” and

“AUTO-IDLE MINUTES” shows in the display, along with the preset time.

g.Press to set the minutes the cooker stays idle before theAuto-idle is enabled; 60 the maximum, OFF the minimum. Ex: “30” in the display means, if product is not cooked in that frypot for 30 minutes, the control automatically activates the idle setpoint temperature, programmed above.

h.Press and release . “SP-7C” and “GO IDLE AT MELT ?” shows in display.

i.Press to toggle from NO to YES, or vice versa. With “YES” in the display, the fryer automatically enters the Idle Mode once the Melt Mode is exited.

Filter Tracking Enabled (Sp-8)

The controls can be set to signal the operator when the shortening needs filtering. The Filter Tracking must be enabled to program the number of cook cycles between filtering procedures. (See Filter Cycles section 2-2.)

a.Follow steps 1 and 2 above.

b.Press and release until “SP-8”

and “FILTER TRACKING ENABLED” flashes on the display, along with “1,OFF”.

c. To enable the filter tracking, press to toggle the display from “1,OFF”, to “2,MIXED”, to, “3,GLOBAL”, or “4SCHED”.

The Mixed setting allows the operator to set different amounts of Cook Cycles between filters, for each product. If the operator wants to have one setting for all products go to step h.

MIXED

d. If “2,MIXED” is selected, press and “SP-8A” shows in the display followed by “SUGGEST FILTER AT …” and a value between 75% and 100%. Press and release

the to change this value.

e.Press and “SP-8B” shows in the display followed by “LOCKOUT ENABLED?” and “YES” or “NO”.

Press and release to choose yes or no.

1005 3-30