Contents
SECTION 3. OPERATION 3-1. OPERATING COMPONENTS
Drain Interlock Switch
Carrier
Drain Valve
3-1. OPERATING COMPONENTS
When hot shortening is in this pan, use extreme care to
Continued
High Limit
INDICATORS
SWITCHES AND
Description
Function
Description
3-3. SWITCHES AND INDICATORS Continued
Function
Window
Model OFE
3-4. CLOCK SET
14. Press
THE FRYPOT CAUSING SERIOUS BURNS, PER
ABOVE THE UPPER LEVEL INDICATOR LINE
3-5. FILLING OR ADDING SHORTENING
BE CERTAIN THE SHORTENING IS NEVER
and hotter at the top. With bigger loads, however, there is generally
3-6. PRODUCT RACKING
RECOMMENDATIONS
Follow the procedures below on the initial start-up of the fryer, and
flashes until 5 before setpoint illuminates and the selected
Unlatch and raise the lid cautiously
1. To protect the shortening when the fryer is not in immediate
3-9. FILTERING INSTRUCTIONS continued
BRUSH ALL CRACKLINGS FROM FRYPOT
3-9. FILTERING INSTRUCTIONS Continued
SURFACES AND THE COLD ZONE DURING THE
FILTERING PROCESS. FAILURE TO DO SO CAN
c. Rinse the frypot interior. Especially work on hard to clean
Lift the filter screen assembly from the drain pan
3-11. FILTER PUMP MOTOR PROTECTOR-MANUAL RESET
3. Close the drain valve and discard the shortening
Using the fryer brush Henny Penny part number
Cleaning Nylatrons - Monthly
Procedure Frequency
MAINTENANCE
3-14. PREVENTIVE
Continued
3-15. PROGRAMMING
Change Product Names
8. Press and release
14. Filter Cycle Mode Optional
3-15. PROGRAMMING Continued
13. Go to Idle after Done?
Continued
3-15. PROGRAMMING
“2,Mixed”
“3,GLOBAL”
Press NO, or don’t press any button for 20 seconds, the controller displays “X CANCELED X” and abandons the copy process. In this case no changes are made
3-16. SPECIAL PROGRAM
3-16. SPECIAL PROGRAM
Audio Volume SP-4
Language SP-2
MODE Continued
The type of shortening being used in the fryer determines the amount of heat applied during the Melt Cycle. If the controls are set to the solid setting, less heat is applied to the shortening, than if the controls were set to liquid. Too much heat applied to solid shortening causes much smoking, and could cause a fire. Match this setting to the type of shortening being used at the time
MIXED
Filter Tracking Enabled Sp-8
GLOBAL
3-16. SPECIAL PROGRAM
MODE Continued
m. If “4,SCHED” is selected, “SP-8A” shows in the display, and
3-16. SPECIAL PROGRAM
3-16. SPECIAL PROGRAM MODE ContinuedProgram Code Change SP-15
Usage Code Change SP-16
3-16. SPECIAL PROGRAM
Change Shortening-A-Cook Cycles SP-18
e. If satisfied with code, press
“*CODE CHANGE*”
operator’s performance. Press and at the same time
Only if Presently Cooking
Reset usage data
was manually reset
4. REVIEW USAGE
Press to view the accumulated information since the data
Press to continue onto OUTP H* P
Continued
3-18. INFORMATION MODE
7. OIL TMP
8. CPU TMP
