Henny Penny OFE- 291 manual Information Mode, Function Display EX

Model OFE- 291

3-18. INFORMATION MODE	4. REVIEW USAGE
(Continued)	Press to view the accumulated information since the data
	was manually reset:

FUNCTION	DISPLAY EX:
Day the usage data was previously reset	SINCE	APR-19
Number of hours the fryer was on	PWR ON HRS		165
Number of times oil was filtered	FILTERED		34
Total number of cook cycles	TOTAL CK		462
Cook Cycles stopped before “DONE”	QUIT COOK		4
Percentage of Cook Cycles before oil change	OIL WEAR -A-		73%
Percentage of hours before oil change	OIL WEAR -B-		47%
Cook Cycles for Product #1	COOKED -1- 193
Cook Cycles for Product #2	COOKED -2- 107
Cook Cycles for Product #3	COOKED -3-		58
Cook Cycles for Product #4	COOKED -4-		0
Cook Cycles for Product #5	COOKED -5-		13
Cook Cycles for Product #6	COOKED -6-		69
Cook Cycles for Product #7	COOKED -7-		0
Cook Cycles for Product #8	COOKED -8-		7
Cook Cycles for Product #9	COOKED -9-		15
Cook Cycles for Product #0	COOKED -0-		0
Reset usage data:
Enter the Mgr Code (1, 2, 3 unless changed)
on this step to zero out all the usage	RESET USG/
information.	ENTER CODE----

Press	to continue to INP A_CVHDSF_M
5. INP A_CVHDSF_M
Press	to view the status of components and inputs. If the

input signal is detected, an identifying letter is displayed (see below). If the signal is not detected, “_” is displayed.

With the COOK/PUMP switch in the COOK position, and all inputs detected, “H_ P_ A_CVHDSF_M” shows in the display. See below for “definition” of codes.

A = COOK/PUMP in COOK position. B = COOK/PUMP in PUMP position

C = Solenoind continuity; won’t show on open fryers V = Volts - 24 VAC detected

H = High Limit - If “H” is present, the high limit is good; if “H” is missing, the high limit is tripped (overheated) or faulty

D = DRAIN SWITCH-If “D” is present, the drain handle is closed; if “D” is missing, the drain is open or faulty

S = COOK/PUMP switch ON interlock circuit: If “S” is

	present, the COOK/PUMP switch is in the COOK position.
	If the “S” is missing, the COOK/PUMP is either off, failed,
	or wired incorrectly
	F = FAN
1005	M = MV-Detects 24 V jumper to MV terminal
	3-38