Henny Penny OFE- 291 Change Shortening-A-Cook Cycles SP-18, Special Program, “*Code Change*”

		Model OFE- 291
3-16. SPECIAL PROGRAM	e. If satisfied with code, press	. “*CODE CHANGE*”
MODE (Continued)	shows in display.
	f. If not satisfied with code, press	and

*CANCELLED* shows in display, then reverts back to “SP-16” and “CHANGE USG CODE ? 1=YES”. Then the above steps can be repeated.

Change Shortening-A-Cook Cycles (SP-17)

The operator can set a reminder to filter the shortening, based on the number of Cook Cycles accumulated. The display shows “CHANGE OIL SOON” when the preset number of Cook Cycles has been met, “OFF” to 5000, increments of 10.

a.Follow steps 1 and 2 above.

b.Press until “SP-17” and “CHANGE OIL’A – COOK CYCLES” shows in display, along with a number of Cook Cycles.

c. Press and release to change the number of Cook Cycles.

Change Shortening-A-Cook Cycles (SP-18)

The operator can set a reminder to filter the shortening, based on the number of power-on hours accumulated. The display shows “CHANGE OIL SOON” when the preset number of hours has been met, “OFF” to 999 hours.

a. Follow steps 1 and 2 above.

b. Press until “SP-18” and “CHANGE OIL’ B – HOURS” shows in display, along with a number of hours.

c. Press and release	to change the number of
power-on hours.

3-17. DATA LOGGING, HEAT CONTROL, TECH MODE, AND STAT MODE

3-35

Once the shortening is filtered, to clear the display of “CHANGE OIL SOON” (SP-17 & SP-18), reset the review usage data in the Information Mode. See Information Mode section of this manual.

Press and hold	at any time to exit Special Program
Mode.

The Data Logging, Heat Control, Tech and Stat Modes are advanced diagnostic and program modes, mainly for Henny Penny use only. For more information on these modes, contact the Service Department at 1-800-417- 8405, or 1-937-456-8405.

1005