Heritage Series ADSL Bridge/ Router

85

Command Sets for Command Line Interface

Example:

DSL> ip enable vlane 192.168.56.3 ip/vlane: IP address 192.168.56.3 DSL> ip device

# type dev file IP address

device ether ether //nice mtu 1500 192.168.2.1 device vlane ether //lane mtu 1500 192.168.56.3

6. get

Syntax:

get <file>

Description:

Reads and executes commands from a file. The commands in the file are in the same format as those documented in this chapter, with no “ip” prefix. They can contain comments, introduced by the “#” character. The “get” command is “hidden”, not shown by “ip help”.

Example:

DSL> ip get //isfs/cmdfile

7. ipatm abort

Syntax:

ipatm abort <n>

Description:

Closes an IP-over-ATM SVC; the number <n> is as displayed by

ipatm files”. If there is still traffic being sent to the destination concerned, IP will soon open a new SVC to the destination.

Example:

DSL> ip ipatm abort 14

8. ipatm arp

Syntax:

ipatm arp [list]

Description:

Lists the cached mappings from IP addresses to ATM addresses; only relevant when using IP-over-ATM with SVCs. (The “list” parameter is optional and makes no difference to the behavior.)

Example:

DSL> ip ipatm arp

192.168.5.72 47.00.83.10.a2.b1.00.00.00.00.00.00.00.00.20.2b.01.00.07.00 192.168.5.33 47.00.83.10.a4.00.00.00.00.00.00.00.00.00.20.2b.01.00.19.00 192.168.5.111 47.00.83.10.e2.00.00.00.20.2b.01.01.a8.00.20.2b.01.01.a8.00

Page 90
Image 90
Heritage Kayaks Heritage Series manual Get, Ipatm abort, Ipatm arp