Heritage Kayaks Heritage Series manual Relay, Command

Enables forwarding:

from every interface to every non-loopback interface

from if1 to every non-loopback interface, and from every interface to if1

90 Command Sets for Command Line Interface

RPORT provided the protocol type (UDP or TCP) is appropriate. They are also displayed in place of port numbers, when a suitable mapping exists.

“<protocol>” should be either “UDP” or “TCP”; it can be omitted, but that is not very useful. For “portname read”, the file is in the same format as //isfs/services, which is the same as the output from “portname list”. The “portname” command is “hidden”, not shown

by “ip help”.

Configuration saving saves this information.

Example:

DSL> ip portname flush

DSL> ip portname add someport 105/tcp

DSL> ip portname list

someport 105/TCP

DSL> ip portname read //isfs/services

DSL> ip portname list

router 520/UDP snmp 161/UDP tftp 69/UDP telnet 23/TCP someport 105/TCP

17. relay

Syntax:

relay

relay all <i/f> [<i/f>] [forward]

Description:

Displays or sets what forwarding TCP/IP will do between interfaces. The combinations of setting forwarding can be a bit confusing; they behave as follows:

Command:

relay all

relay if1

relay if1 forward

from if1 to every non-loopback interface

relay if1 if2 from if1 to if2 and from if2 to if1 relay if1 if2 forward

from if1 to if2

(Don’t confuse the “forward” keyword, which indicates one-way relaying, with the term “forwarding”!)