HotBrick, Tel:
3.:LLoadbalancingB e
This screen is only operational if using Internet connections on both WAN ports
Figure 3-2: Load Balance
LoaddbalancingB e – Load Balancing
Enable – Use this to enable your Load Balance settings. Unless this is checked, the other settings on this screen have no effect.
Balance Type – Select the desired option:
•Bytes rx+tx – Traffic is measured by Bytes.
•Packets rx+tx – Traffic is measured by Packets.
•Sessions established – Traffic is measured by Sessions.
•IP Address – Traffic is measured by IP Address.
Loading Share on WAN 1 – Enter the percentage (%) of traffic to be sent over WAN 1. If one WAN port connection has greater bandwidth than the other, the one with the greater bandwidth should be given a higher percentage of traffic than the other.
NAT statistics This section displays the current data about WAN 1 and WAN 2. You can use this information to help you
Interface statistics This section displays cumulative statistics. Use the "Restart Counters" button to restart these counters when required.
20
