HotBrick, Tel: 305 -398-0888, Fax: 305-398-5966
Advanced configuration – Routing
Routing
This section is only relevant if your LAN has other Routers or Gateways.
If you don't have other Routers or Gateways on your LAN, you can ignore the Static Routing page completely.
If your LAN has other Gateways and Routers, you must configure the Static Routing screen as described below. You also need to configure the other Routers.
Note:
If there is an entry or entries in the Routing table with an Index of zero (0), these are System entries. You cannot modify or delete these entries.
Dynamic routing
RIP v2 – This acts as a “master” switch. If enabled, the selected WAN or LAN will run RIPv1/v2. Otherwise theRIP function is not available.
Interface – LAN, WAN1 – n, is enabled, any WAN or LAN can execute the RIP function.
Static routing
Network Address – The network address of the remote LAN segment. For standard class "C" LANs, the network address is the first 3 fields of the Destination IP Address. The 4th (last) field can be left at 0.
Netmask
27
