HotBrick VPN 800/8 F manual VPN Configuration Tunnel to 3rd Party,  Action

HotBrick, Tel: 305 -398-0888, Fax: 305-398-5966

VPN Configuration - Tunnel to 3rd Party







Tunnel to 3rd Party - This describes an IPsec tunnel from a VPN800/8 F with a non-Hotbrick certified unit.

VPN Tunnel List– here you can add a new tunnel or change an existing one from the list. The router allows a maximum of 50 tunnels.

Tunnel Name– In order to distinguish the tunnels, you have to give the “Tunnel” a unique name.

Tunnel – The tunnel can be connected only after the tunnel check box is enabled.

WAN port – You can choose WAN1, WAN2 or Any to make the VPN connection.

Local Security Network– These entries identify the private network on this VPN router. The Network hosts can use the LAN-to-LAN connection. You can choose a single IP address, the subnet, or a selected IP range to make a VPN LAN-to-LAN connection.

Remote Security Network– These entries identify the private network on the remote peer VPN

router whose hosts can use the LAN-to-LAN connection. You can choose a single IP address, the subnet, or a selected IP range to make a VPN connection

Remote Security Gateway – You can select the remote-side IP address (WAN IP address) as your remote security gateway

Preshared key - Choose a shared secret for this entry. They must be the same on both units.

Action

Connect – this button will initiate the tunnel Submit Query – this button will add the policy

50