HP 3150 manual Heating element removal 1

Heating element

1Remove all covers, the RFI shield, the printer door, the exit roller, the delivery assembly, the fuser pressure plate, and the front casing.

2Disconnect the AC voltage to the heating element by releasing the connector located on the ECU. Press down on the connector release with the small flatblade screwdriver (callout 1). (Because this is a small space, it is much easier to reach the connector with a screwdriver.) Pull the connector straight out (callout 2).

1

2

Figure 45. Heating element removal (1 of 2)

3Remove the wire from the wire guides along the right side of the printer.

EN Internal assemblies 117