Problem

Cause

Solution

When the product is connected to the network using an HP JetDirect print server, you receive this message: “JetSuite Fax has detected that the HP LaserJet 3150 is either switched off or is not connected to your computer.”

The power cord is loose.

Make sure the power cord is securely connected

 

between the HP LaserJet 3150 product and the

 

power source. Also, ensure the power cord for the

 

HP JetDirect print server is securely connected to

 

the power source.

The network cord is loose.

Ensure the network cable is securely connect

 

between the HP JetDirect print server and the

 

wall outlet for the network. Also ensure the

 

network cable between the computer and the wall

 

is securely connected.

The parallel cable is loose or not directly connected.

The parallel cable may be faulty.

The HP JetDirect print server may not be configured yet (TCP/IP).

HP JetDirect print server is incorrectly configured (TCP/IP).

Make sure the parallel cable between the

HP JetDirect print server and the HP LaserJet 3150 product is securely connected.

If you have another “size C” parallel cable, try connecting it between the HP LaserJet 3150 product and the HP JetDirect print server.

Use the HP JetAdmin software, the HP WebJet Admin software, BOOTP, DHCP, or telnet to configure the HP JetDirect print server.

See the documentation that came with the HP JetDirect print server for troubleshooting information.

When the product is connected to the network using an HP JetDirect print server, you receive this message: “All in One configuration cannot continue because the required protocols were not found on your computer.”

The IPX/SPX or TCP/IP protocols are not installed on your computer.

Install an IPX/SPX protocol that is compatible with NW Link or a TCP/IP protocol on your computer.

EN

Solving general software problems 171

Page 173
Image 173
HP 3150 manual Is securely connected