HP 3150 manual Self-test in extended service mode, Fax memory test #1 Program test #1

	Self-test in extended service mode
	If you perform a self-test from the extended service menu, the printed
	report will also show firmware revision number and details.
Note	Print the internal reports before performing extended service mode
	tests. The reports contain a record of all settings and can assist you in
	restoring the product to its settings.
	The table below lists the tests that are performed during a self-test
	and the actions to take when tests fail:

Table 15. Extended service mode self-test failures

Test	If the test fails, take these actions:
Configuration test #1	Replace the formatter.
Fax memory test #1
Program test #1	1.	Cycle power by unplugging the power cord from the power source,
		waiting 10 seconds, and replugging in the power cord.
Configuration test #2
	2.	If the test fails again, clear all memory (see the extended service menu
Configuration test #3		tree).
	3.	If the test fails again, replace the formatter.
Configuration test #4
Fax memory test #2
Fax memory test #3
Fax memory test #4
Fax memory test #5
Modem 1 test #1
Modem 1 test #2
Modem 1 test #3
Modem 1 dial tone	1.	Make sure that the telephone cable is plugged into the correct connector
detect		on the product and that the telephone line is operational (use a telephone
		to test the line).
	2.	If the test fails again, check the configuration settings in the control panel.
	3.	If the test fails again, replace the LIU.
Scanner test #1	This test fails under normal conditions if the document scanner is busy. If the
	document scanner is not busy:
	1.	Cycle power by unplugging the power cord from the power source,
		waiting 10 seconds, and replugging in the power cord.
	2.	If the test fails again, clear all memory (see the extended service menu
		tree).
	3.	If the test fails again, replace the formatter.

EN Service menus 193