HP 3150 manual Separation pad removal

Separation pad

1Remove all covers, the RFI shield, the printer door, the LIU board, the formatter board, the metal side plate, the paper pickup gear, the pickup roller assembly, and the kick plate.

2Lift the bottom of the white plastic tab (callout 1) on the rear of the paper feed frame up slightly and slide it up, toward the top of the paper feed frame. This will release the separation pad.

3Lift the separation pad 90 degrees and slide its mounting pins out of their retainers.

1

Figure 63. Separation pad removal

Note	If you replace the separation pad, also replace the pickup roller
	assembly and subpads. See the removal procedures for subpads on
	the following page and also see Figure 96, “Paper pickup assembly,”
	in Chapter 7.

EN Internal assemblies 135