Testing Calculator Operation

Use the following guidelines to determine if the calculator is working properly. Test the calculator after every step to see if its operation has been restored. If your calculator requires service, refer to page A–7.

The calculator won't turn on (steps 1–4) or doesn't respond when you press the keys (steps 1–3):

1.Reset the calculator. Hold down the †key and press -. It may be necessary to repeat these reset keystrokes several times.

2.Erase memory. Press and hold down †, then press and hold down both <and 6, Memory is cleared and the &  message is displayed when you release all three keys.

3.Remove the batteries (see "Changing the Batteries") and lightly press a coin against both battery contacts in the calculator. Replace the batteries and turn on the calculator. It should display & .

4.Install new batteries (see "Changing the Batteries").

If these steps fail to restore calculator operation, it requires service.

If the calculator responds to keystrokes but you suspect that it is malfunctioning:

1.Do the self–test described in the next section. If the calculator fails the self test, it requires service.

2.If the calculator passes the self–test, you may have made a mistake operating the calculator. Reread portions of the manual and check "Answers to Common Questions" (page A–1).

3.Contact the Calculator Support Department. The address and phone number are listed on the inside back cover.

A–4

Support, Batteries, and Service

File name 32sii-Manual-E-0424

 

Printed Date : 2003/4/24

Size : 17.7 x 25.2 cm