Switch Memory and Configuration

Using the Menu and Web Browser Interfaces To Implement Configuration Changes

To save and implement the changes for all parameters in this screen, press the [Enter] key, then press [S] (for Save). To cancel all

changes,

press the

[Enter] key, then

press [C] (for Cancel)

 

 

Figure 6-4. Example of Pending Configuration Changes You Can Save or Cancel

 

 

 

N o t e

 

If you reconfigure a parameter in the CLI and then go to the menu interface

 

 

without executing a write memory command, those changes are stored only in

the running configuration (even if you execute a Save operation in the menu interface). If you then execute a switch boot command in the menu interface, the switch discards the configuration changes made while using the CLI. To ensure that changes made while using the CLI are saved, execute write memory in the CLI before rebooting the switch.

Rebooting from the Menu InterfaceTerminates the current session and performs a reset of the operating systemActivates any configuration changes that require a reboot

Resets statistical counters to zero

(Note that statistical counters can be reset to zero without rebooting the switch. See “To Display the Port Counter Summary Report” on page 18.)

To Reboot the switch, use the Reboot Switch option in the Main Menu. (Note that the Reboot Switch option is not available if you log on in Operator mode; that is, if you enter an Operator password instead of a manager password at the password prompt.)

6-11