HP ProCurve 6600 all, show, savepower, savepower module, Show Savepower Module, show save- power module, Figure I-3.Example of savepower port-low-powerCommand for Slot C

Power-Saving Features

Configuring the Savepower port-low-pwr Option

The port-low-pwroption puts the slots into auto low power mode if they are not linked. If a particular slot is specified, only that slot goes into auto low power mode. Specifying all puts all the slots into auto low power mode.

The ports in low power mode periodically monitor to determine if the link has become active. If a LAN cable is connected to one of the ports, that port will come out of the low power mode state after approximately 2 seconds (the monitor period) and enter into normal power mode. The remaining ports continue to be in low power mode.

The no form of the command puts the specified slot into normal power mode. Specifying all with the no form of the command puts all the slots into normal power mode.

ProCurve(config)# savepower port-low-pwr c

ProCurve(config)# show savepower port-low-pwr

Port Save Power Information

Slot Status

----+ --------

A Disabled B Disabled C Enabled D Disabled E Disabled

Figure I-3. Example of savepower port-low-power Command for Slot CShow Savepower Commands

The settings for the savepower commands can be viewed using the appropriate show command.

Show Savepower Module.

To display the settings for the savepower module command, use show save- power module.

I-6