HP ProCurve 6600 Using Redundant Management, Displaying Redundancy Status

Redundancy (Switches 8200zl)

Using Redundant Management

Using Redundant Management

There are new CLI commands for redundant management as well as modifications to existing commands. (See “Existing CLI Commands Affected by Redundant Management” on page 15-29)

New Redundant Management Commands	Page
redundancy management-module	below
redundancy switchover	15-8
redundancy active-management	15-9
redundancy fabric-module	15-12
show redundancy	15-5;15-27

Displaying Redundancy Status

You can display the status of both the management and fabric redundant modules using this command:

Syntax: show redundancy

Displays the status of the management and fabric modules.

An example of the output for the show redundancy command is seen in Figure 15-1.

15-5