HP ProCurve 6600 Figure, standby module, and Hotswapped Module” on page 15-16 for more information, When you enter the show redundancy command and a software version

	Redundancy (Switches 8200zl)
	Downloading a New Software Version
C a u t i o n	If you have booted one module out of primary flash and one module out of
	secondary flash, and the secondary flash is running a prior software version
	because the latest version was never copied over from the primary flash, you
	will have an software version mismatch. The configuration file may not work
	with that software version. See “Software Version Mismatch Between Active
	and Hotswapped Module” on page 15-16for more information.
	Additionally, if a switchover occurs, or if you reboot to make the standby
	module become the active module, any configuration file changes made may
	not work on the active module if it has a different software version from the
	standby module.
	When you enter the show redundancy command and a software version
	mismatch exists, a warning message is displayed, as shown at the bottom of
	Figure 15-11.

15-19