HP ProCurve 6600 Management, Additional Commands Affected by Redundant, The other existing commands operate with redundant management as shown below

Redundancy (Switches 8200zl)

Existing CLI Commands Affected by Redundant Management

Additional Commands Affected by RedundantManagementThe other existing commands operate with redundant management as shown below.

Command	Action
auto-tftp	If a new image is downloaded using auto-tftp, the active
	management module downloads the new software version to both
	the active and standby modules. Rebooting after the auto-tftp
	completes reboots the entire system.
banner	The banner will not been seen on the standby module, only the
	active module.
chassislocate	If the management module performs a switchover, the LED does
	not remain lit.
clear	The clear crypto command causes public keys to be deleted from
	both modules when the second module is in standby mode.
console	Console settings, such as mode, flow-control, and baud-rate, are
	the same on both management modules. There cannot be
	individual settings for each management module.
copy	Files are automatically sync’d from the active management module
	to the standby management module.
	When no parameter is specified with the copy crash-dataor copy
	crash-logcommand, files from all modules (management and
	interface) are concatenated. See “Crash Files” on page 15-42.
	Note: If redundancy is disabled or the standby module failed
	selftest, the copy command affects only the active management
	module.
crypto	Authentication files for ssh or the https server are copied to the
	standby management module. The clear crypto command deletes
	the public keys from both modules when the second module is in
	standby mode.
erase flash	Erases the software version on the active and standby modules. If
	redundancy has been disabled, or the standby module has not
	passed selftest, the flash is not erased on the standby module.
erase config	Erases the config file on the active and standby modules. If
	redundancy has been disabled, or the standby module has not
	passed selftest, the config file is not erased on the standby module.
erase startup-config	Affects both modules if the second module is in standby mode. If
	redundancy has been disabled, or the standby module has not
	passed selftest, the startup-config file is not erased on the standby
	module.

15-34