File Transfers

Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation

slot-id:retrieves the crash data from the module in the specified slot.

mm:retrieves the crash data from both management modules and concatenates them.

oobm: For switches that have a separate out-of-band management port, specifies that the transfer will be through the out-of-band management interface. (Default is transfer through the data interface.)

Copying Crash Log Data Content to a Destination Device

Syntax: copy crash-log [<slot-id mm>] tftp <ip-address> <filepath and filename> [oobm]

copy crash-log [<slot-id mm>] usb <filename>copy crash-log [<slot-id mm>] xmodemwhere: slot-id= a - h, and retrieves the crash log fromthe processor on the module in the specified slot.

mmRetrieves the crash log from the switch’s chassis processor. When mm is specified, crash files from both management modules are copied.

oobm For switches that have a separate out-of-band management port, specifies that the transfer will be through the out-of-band management interface. (Default is transfer through the data interface.)

These commands copy the Crash Log content to a remote host, attached USB device, or to a serially connected PC or UNIX workstation. You can copy individual slot information or the management module (mm) switch information. If you do not specify either, the command defaults to the mm data.

For example, to copy the Crash Log for slot C to a file in a PC connected to the switch:

A-43