HP ProCurve 6600 Figure 13-2.Example of Rate-LimitSettings Listed in the “show config” Output, Rate-limiting, , regardless of traffic priority

Ports A1-A4 are configured with an outbound rate limit of 200 kbps.

Port A5 is configured with an inbound rate limit of 200 kbps.

Port A6 is configured with an inbound ICMP and multicast rate-limits of 60 percent each.

Port Traffic Controls

Rate-Limiting

ProCurve(config)# show config

Startup configuration:

; J8697A Configuration Editor; Created on release #K.14.01

hostname "ProCurve Switch 8212zl" module 1 type J8705A

snmp-server community "public" Unrestricted vlan 1

name "DEFAULT_VLAN" untagged A1-A24

ip address dhcp-bootp exit

interface A1

rate-limit all out kbps 200 exit

interface A2 rate-limit all out kbps 200 exit

interface A3

rate-limit all out kbps 200 exit

interface A4

rate-limit all out kbps 200 exit

interface A5

rate-limit all in percent 200 exit

interface A6 rate-limit icmp percent 60 rate-limit mcast in percent 60

exit

Figure 13-2. Example of Rate-Limit Settings Listed in the “show config” OutputOperating Notes for Rate-Limiting

■Rate-limiting operates on a per-port basis, regardless of traffic priority. Rate-limiting is available on all types of ports (other than trunked ports) on the switches covered in this guide, and at all port speeds configurable for these devices.

■Rate-limiting is not allowed on trunked ports: Rate-limiting is not supported on ports configured in a trunk group (including mesh ports). Configuring a port for rate-limiting and then adding it to a trunk suspends

13-8