Redundancy (Switches 8200zl)

Using Redundant Management

ProCurve(config)# redundancy switchover

This management module will now reboot from primary image and will become the standby module! You will need to use the other management module's console interface. Do you want to continue [y/n]? y

ROM information:

Build directory:

/sw/rom/build/bmrom(t2g)

Build date:

Mar 15 2007

Build time:

08:24:27

Build version:

K.12.02

Build number:

13040

Select profile (primary):

Booting Primary Software Image...

.

.

.

Standby Console#

Figure 15-4. An Example of the Redundancy Switchover CommandSetting the Active Management Module for Next Boot

You can select which management module you want to be the active management module at the next “boot system” or switchover event. Enter this command:

Syntax: redundancy active-management <standby management-module1 management-module2>

The specified module becomes the active management module at the next system boot. This message displays: “On the next system boot, the <module specified> will become active.”

This command will not take effect if the standby management module has failed selftest.

management-module1:Configures management-module 1 as the active management module for the next system boot.

management-module2:Configures management-module 2 as the active management module for the next system boot.

standby: Configures the current standby module as the active management module for the next system boot if redundancy is enabled. If redundancy is disabled, it will become enabled as a standby module at the next boot or failover event.

15-9