HP ProCurve 6600 Manually Configuring PoE Power Levels, poe­, value, allocate-by, power-over-ethernet, Then select a value:, or in interface context:

Power Over Ethernet (PoE/PoE+) Operation

Configuring PoE Operation

Manually Configuring PoE Power Levels

You can specify a power level (in watts) allocated for a port by using the value option. This is the maximum amount of power that will be delivered.

To configure a port by value, first set the PoE allocation by entering the poe­ allocate-by value command:

ProCurve(config)# int A6 poe-allocate-by valueor in interface context:ProCurve(eth-A6)# poe-allocate-by valueThen select a value:ProCurve(config)# int A6 poe-value 15

or in interface context:

ProCurve(eth-A6)# poe-value 15To view the settings, enter the show power-over-ethernetcommand:

ProCurve(config)# show power-over-ethernet A6

Status and Counters - Port Power Status for port A6

Power Enable			: Yes		LLDP Detect				: enabled
Priority			:	low	Configured	Type			:
											Maximum
										15 W
	AllocateBy		: value		Value			:			power
Detection Status			: Delivering		Power Class		: 2				delivered
Over Current Cnt		: 0			MPS Absent Cnt		: 0
Power Denied Cnt		: 0			Short Cnt		: 0
Voltage			: 55.1 V		Current				: 154 mA
Power			: 8.4 W

Figure 11-1. Example Displaying PoE Allocation by Value and the Maximum Power Delivered

If you set the PoE maximum value to less than the PD requires, a fault occurs.

11-13