HP ProCurve 6600 •PIM, •OSPF, •MAC lockout, •MAC lockdown, •Loop protection, •Virus throttling, ■Access Security Guide:, ■Multicast and Routing Guide:

Configuring for Network Management Applications

Using SNMP Tools To Manage the Switch

■Advance Traffic Management Guide:•Loop protection•Spanning Tree (STP, RSTP, MSTP)■Access Security Guide:•MAC lockdown•MAC lockout•Uni-Directional Link Detection (UDLD)•Virus throttling■Multicast and Routing Guide:•OSPF•PIM•Virtual Router Redundancy Protocol (VRRP)General Steps for Configuring SNMP NotificationsTo configure SNMP notifications, follow these general steps:

1.Determine the versions of SNMP notifications that you want to use in your network.

If you want to use SNMPv1 and SNMPv2c traps, you must also configure a trap receiver. Refer to the following sections and follow the required configuration procedures:

•“SNMPv1 and SNMPv2c Traps” on page 14-19•“Configuring an SNMP Trap Receiver” on page 14-19•“Enabling SNMPv2c Informs” on page 14-21

If you want to use SNMPv3 notifications (including traps), you must also configure an SNMPv3 management station. Follow the required configu­ ration procedure in the following section:

•“Configuring SNMPv3 Notifications” on page 14-23

2.To reconfigure any of the SNMP notifications that are enabled by default to be sent to a management station (trap receiver), refer to these sections:

•“Enabling Link-Change Traps” on page 14-28

3.(Optional) Refer to the following sections to configure optional SNMP notification features and verify the current configuration:

•“Configuring the Source IP Address for SNMP Notifications” on page 14-29•“Displaying SNMP Notification Configuration” on page 14-31

14-18