HP ProCurve 6600 Transferring Switch Configurations, A-29, k0800.swi, Procurve# copy xmodem flash, 1.Execute the following command:, 2.Execute the following command:

File Transfers

Transferring Switch Configurations

For example, to copy the primary flash image to a serially connected PC:1.Execute the following command:Procurve# copy xmodem flashPress ‘Enter’ and start XMODEM on your host...2.After you see the above prompt, press [Enter].3.Execute the terminal emulator commands to begin the file transfer.USB: Copying a Software Image to a USB Device

To use this method, a USB flash memory device must be connected to the switch’s USB port.

Syntax: copy flash usb < filename>

Uses the USB port to copy the primary flash image from the switch to a USB flash memory device.

For example, to copy the primary image to a USB flash drive:1.Insert a USB device into the switch’s USB port.2.Execute the following command:Procurve# copy flash usb k0800.swi

where k0800.swi is the name given to the primary flash image that is copied from the switch to the USB device.

Transferring Switch Configurations

Transfer Features

Feature	Page
Use TFTP to copy from a remote host to a config file.	A-31
Use TFTP to copy a config file to a remote host.	A-33

Use Xmodem to copy a configuration from a serially connected host to a config file. A-33

Use Xmodem to copy a config file to a serially connected host.	A-33
Use USB to copy a configuration from a USB device to a config file.	A-35
Use USB to copy a config file to a USB device.	A-35

A-29