HP 22A, 83620A, 24A Dblr Amp Menu, Programming Codes SCPI NONE, Function Group P O W E R Menu Map

D

Dblr Amp Menu

Function Group P O W E R

Menu Map 5

Description This softkey accesses the doubler amp mode softkeys. These softkeys are applicable to instrument models with a doubler installed. The doubler has an integral amplifier whose operation is controlled by the instrument firmware. Its use depends on the frequency of operation and on the calibration constants set at the factory. The instrument defaults after preset to this automatic mode of operation which is the specified operation. Softkeys in this menu will allow you to turn the doubler amplifier always on or always off. These two modes are unspecified operation for instruments with a doubler installed. These softkeys have no effect on instruments without a doubler.

Doubler Amp Mode AUTO	Sets the doubler amp mode to
	AUTO. This is the default after
	preset and must be used for specified
	performance.
Doubler Amp Mode On	Turns the doubler amplifier on
	regardless of the frequency of
	operation. Using this mode results in
	unspecified performance.

Doubler &rip Mode Off

Programming Codes SCPI: NONE

Analyzer: NONE

Turns the doubler amplifier off regardless of the frequency of operation. Using this mode results in unspecified performance.

See Also Softkeys listed above.

HP 8360	Operating and Programming Reference D-l
User’s Handbook