HP 83620A, 24A, 22A manual Daubler Amp Mode Auto, Function Group Power Menu Map

Disp S t a t u s

Table D-l.

Mnemonics used to Indicate Status (continued)

Function			Mnemonic	State	Mnemonic
Flatness On/Off			usrcorr	Off	Off
				On	On
Start	Sweep	Trigger	SwpTrig	Automatic	Auto
				HP-IB	Bus
				External	Ext
Power	Slope		Rf Slope	Off	Off
				On	On
Power Sweep			Pwr Swp	Off	Off
				On	On
Sweep Mode			SwpMode	Ramp	Swept
				Step	Step
				List	List
				c w	c w
				Span=0	Zero Span
Peak RF Always			AutoCal	On	Peaking or
					Peak
AM BW Cal Always AutoCal				On	AM BW or
					AmBw or
					Am
SwpSpan Cal		Always	AutoCal	On	SweptFreq or
					Freq or Frq

Programming Codes SCPI: NONE

Analyzer: NONE

See Also STATUS MESSAGES

Daubler Amp Mode AUTO

Function Group POWER

Menu Map 5

Description This softkey is applicable to instrument models with a doubler installed. The doubler has an integral amplifier whose operation is controlled by the instrument firmware. The use of the amplifier depends on the frequency of operation and on the calibration constants set at the factory. The instrument defaults after preset to this automatic mode of operation which is the specified operation. This softkey has no effect on instruments without a doubler.

An asterisk next to the key label indicates that this feature is active.

This feature is the default after preset.

D-8 Operating and Programming Reference	HP 8360
User’s	Handbook