HP 24A, 83620A, 22A manual Instrument State

Table 3-8. Programming Language Comparison (continued)

Description	Network	Analyzer		SCPI Language
	Language
Set remote knob	RB
Request status byte mask	R E <num>,RM	<num>	*SRE <num>,	*SRE?
			*ESE <num>,	*ESE?’
Reset sweep	RS		ABOR
Number of steps in	SN <num>		SWE:POIN <num>
a stepped sweep
Swap network analyzer	S W <110>
channels
Test HP-IB interface	TI <num>		DIAG:TINT? <num>
Sets sweep time lower limit	TL <num>time-suffix		SWE:TIME:LLIM		<num>[time-suffix]
Take sweep	TS		TSW;*WAI
Instrument State
Instrument preset	IP		SYST:PRES
Local instrument control	LOCAL 7XX		LOCAL 7XX
			(XX=Source HP-IB address)
Markers [n] is 1 to 5, 1 is default
Turn on and set marker	Mn <num>freq-suffix		MARK[n]:FREQ
			<num>[freq-suffix]
			STAT ON
Turn off frequency marker	MnMO		MARK[n] OFF
Enable Ml-M2 sweep	MPl		SWE:MARK:STAT		ON
Disable Ml-M2 sweep	MPO		SWE:MARK:STAT		OFF
Move start->Ml stop->M2	SHMP		SWE:MARK:XFER
Enable delta marker	MD1		MARK[n]:DELT? <num>,<num>
Disable delta marker	MD0		MARK OFF
Move marker to	MC		MARK[n]:FREQ?;
center frequency			:FREQ:CENT	<response>[freqsuffix]
Turn off all markers	SHMO		MARK:AOFF
Turn on amplitude markers	AK1		MARK[n]:AMPL ON
			;AMPL:VAL <num>[DB]

Turn off amplitude markers

AK0

MARK:AMPL OFF

Specifications INSTALLATION 3-27