3.Connect the other end of the Ethernet cable to an available port on your Ethernet router or switch.

4.Once you have connected the HP All-in-One to the network, install the software.

Related topics

“Install the software for a network connection” on page 21

Finish setup

Install the software for a network connection

Use this section to install the HP All-in-One software on a computer connected to a network. Before you install the software, make sure you have connected the HP All-in- One to a network.

NOTE: If your computer is configured to connect to a series of network drives, make sure that your computer is currently connected to these drives before installing the software. Otherwise, HP All-in-One installation software might try to use one of the reserved drive letters, and you will not be able to access that network drive on your computer.

NOTE: Installation time can range from 20 to 45 minutes depending on your operating system, the amount of available space, and the processor speed of your computer.

To install the Windows HP All-in-One software

1.Quit all applications running on your computer, including any virus detection software.

2.Insert the Windows CD that came with the HP All-in-One into the CD-ROM drive on your computer and follow the onscreen instructions.

3.If a dialog box about firewalls appears, follow the instructions. If you see firewall pop- up messages, you must always accept or allow the pop-up messages.

4.On the Connection Type screen, select Through the network, and then click Next.

The Searching screen appears as the Setup program searches for the HP All-in-One on the network.

5.On the Printer Found screen, verify that the printer description is correct.

If more than one printer is found on the network, the Printers Found screen appears. Select the HP All-in-One you want to connect.

6.Follow the prompts to install the software.

When you have finished installing the software, the HP All-in-One is ready for use.

Connect to a network

21