Chapter 4

setup Finish

4.Click the Settings tab to access device settings.

5.Make any configuration changes, and then click Apply.

6.Close the Embedded Web Server.

Related topics

“View and print network settings” on page 23

Use the Embedded Web Server to modify network settings

The Embedded Web Server gives you an intuitive interface to your network connection parameters.

To use the Embedded Web Server to modify network settings

1.Print a network configuration page to find the IP address for the HP All-in-One.

2.In the Address box in your Web browser on your computer, type the IP address of the HP All-in-One, as shown on the network settings page. For example, http:// 192.168.1.101.

The Embedded Web Server Information page appears, showing information for the HP All-in-One.

NOTE: If you are using a proxy server in your browser, you might need to disable it to access the Embedded Web Server.

3.Click the Networking tab.

4.Click Wired (802.3) in the navigation menu.

5.Make your changes, and then click Apply.

Related topics

“View and print network settings” on page 23

Network configuration page definitions

The network configuration page shows the network settings for the HP All-in-One. There are settings for general information and 802.3 wired (Ethernet).

For information on how to print a network configuration page, see “View and print network settings” on page 23. For additional information on terms used here, see the “Network glossary” on page 29.

This section contains the following topics:

•General network settings

•Wired (802.3) network settings

26 Finish setting up the HP All-in-One