![](/images/new-backgrounds/1241927/24192771x1.webp)
Configure network settings
You can view and configure the network settings from the Embedded Web Server, the HP Utility or the front panel.
●From the Embedded Web Server: Select the Setup tab, then Networking.
●From the HP Utility: You can access the Embedded Web Server through the HP Utility.
●From the front panel: press , then Connectivity.
The following options are available:
●Enable/Disable wireless turns the wireless connection on or off.
●Wireless setup wizard provides an easy way to connect to a wireless network.
●
●Network summary displays information about the wired or wireless network
●Print wireless network test runs diagnostic tests of wireless connectivity
●Print network configuration
●Advanced setup
◦Select I/O timeout sets the time that the printer will wait for the driver to send a job to the printer once the connection has been opened. Values range from half a minute to half an hour.
◦Link speed sets the speed at which data are transmitted over the network. The default is Automatic.
◦IP settings allows you to view or change the IP address, subnet mask, default gateway, and DNS address.
◦Hostname allows you to change the hostname.
●Restore network defaults
Configure firewall settings
Firewall features provide
NOTE: In addition to firewall protection at the network layer, the printer also supports open secure sockets layer (SSL) standards at the transport layer for secure
For firewall operation on the printer, you must configure a firewall policy to apply to specified IP traffic. Firewall policy pages are accessed through the Embedded Web Server and displayed by your Web browser. After a policy is configured, it is not activated until you click Apply in the Embedded Web Server.
28 Chapter 4 Personalizing the printer | ENWW |