Removal and Replacement Procedures— Microtower (µT) Chassis

6.6Memory Modules

ÄCAUTION: The memory module sockets have gold metal contacts. When upgrading the memory, it is important to use memory modules with gold metal contacts to prevent corrosion and/or oxidation resulting from having incompatible metals in contact with each other.

ÄCAUTION: Static electricity can damage the electronic components of the computer or optional cards. Before beginning these procedures, ensure that you are discharged of static electricity by briefly touching a grounded metal object. Refer to Chapter for more information.

ÄCAUTION: When handling a memory module, be careful not to touch any of the contacts. Doing so may damage the module.

1.Prepare the computer for disassembly (Section 6.1, “Preparation for Disassembly”).

2.Remove the access panel and rotate the computer so the system board is parallel to the table to make it easier to work on (Section 6.3, “Access Panel”).

ÅWARNING: To reduce risk of personal injury from hot surfaces, allow the internal system components to cool before touching.

3.Open both latches of the memory module socket 1, and insert the memory module into the socket 2. Begin by installing a module into the socket nearest the preinstalled module, and install the modules following the numerical order of the sockets.

✎A memory module can be installed in only one way. Match the notch on the module with the tab on the memory socket.

4.Push the module down into the socket, ensuring that the module is fully inserted and properly seated. Make sure the latches are in the closed position 3.

5.Repeat steps 3 and 4 for any additional modules that you want to install.

To reassemble the computer, reverse the removal procedure.

6–10

360201-002

Service Reference Guide, dc5000