HP E1200-320 C Inband SCSI-3commands, General commands, Report LUNs command

C Inband SCSI-3 commands

The HP e1200-320 4Gb Interface Card supports a set of SCSI-3 commands that can be received inband over iSCSI/NDMP. When received by the interface card, these commands are then executed by the interface card itself.

When using SCSI-3 commands to access general management features, the commands can be sent to device LUNs that are mapped through the interface card.

The following is a list of the SCSI-3 commands that are supported by the interface card. Complete definitions of SCSI-3 commands can be found in the SCSI-3 standard available from the American National Standards Institute (ANSI).

General Commands

•REPORT LUNS

•INQUIRY

General commands

Following is a description of a general-use SCSI-3 command. For more information about the other general-use commands, please contact your service representative.

Report LUNs command

The interface card supports the Report LUNs command. The Report LUNs command will return a list of Logical Unit Numbers (LUNs) that can receive commands. The format of the report LUNs command is shown in Table 12.

Table 12 Format of Report LUNs command

Bit	7	6	5		4		3	2	1	0
Byte
0				Operation Code ( 0xA0)
1						Reserved
2						Reserved
3						Reserved
4						Reserved
5						Reserved
6						(MSB)
					Allocation Length
7
8
						(LSB)
9
10						Reserved
11						Control Byte

e1200-320 4Gb Fibre Channel Interface Card user and service guide 109