Select 1 to access interface card configuration settings.

Select 2 to access System Utilities.

Select 3 to display trace and assertion history.

Select 4 to reboot the interface card. A confirmation message appears to verify this action.

Enter N to return to the System Utilities menu.

Enter Y to restart the interface card.

Select 5 to download a new revision of the firmware. A confirmation message appears to verify this action. (For additional information see ”Download a new revision of the firmware” on page 88.)

Enter N to return to the Main menu.

Enter Y for the interface card to accept firmware data from the serial port.

Perform configuration

The Perform Configuration menu allows the administrator to configure the various options on the interface card. For most configuration changes to take effect, you must reboot the interface card.

NOTE: Menus are not case sensitive. You can enter uppercase and lowercase characters interchangeably, whenever menus indicate letters as choices.

Figure 41 Configuration menu

Configuration Menu

X.XX.XX XXXXXX XXXXXXXXXXXXXXXX

07/7/2005 08:56:22

1)Baud Rate Configuration

2)Ethernet Configuration

3)Fibre Channel Configuration

4)Parallel SCSI Configuration

5)Device Mapping

6)Trace and Event Settings Configuration

7)Real-Time Clock Configuration

8)Active Fabric Configuration

A)Save Configuration

B)Restore Last Saved Configuration

C)Reset to Factory Defaults

X) Return to main menu

58 Using the Command Line Interface

Page 58
Image 58
HP E1200-320 manual Perform configuration, Configuration menu