HP E1200-320 manual Parallel Scsi configuration, This menu allows for setting up Scsi attributes

Parallel SCSI configuration

This menu allows for setting up SCSI attributes.

Figure 45 Parallel SCSI configuration menu

Parallel SCSI Configuration Menu

X.XX.XX XXXXXX XXXXXXXXXXXXXXXX

07/7/2005 08:56:22

Current SCSI Configuration - Bus 0

Discovery		: Enabled
Bus Reset	on Boot	: Enabled
Discovery	delay time	:	30 seconds
Internal Termination		:	Enabled

1)Edit Initiator Settings

2)Enable/Disable SCSI Discovery

3)Enable/Disable SCSI Reset on Boot

4)Set Discovery Delay Time

5)Set SCSI Termination Mode

6)Set Maximum SCSI Bus Connect Speed

X) Return to previous menu

Command, <enter> for next bus >

Press the Enter key to toggle the current menu to the next SCSI bus.

•Select 1 to edit the SCSI Initiator menu settings, described later in the chapter.

•Select 2 to enable/disable SCSI Discovery.

•Select 3 to enable/disable SCSI bus Reset on Boot. When enabled, the interface card automatically resets SCSI buses after initial library power-up and after reboots.

•Select 4 to set the discovery delay time for SCSI devices. The default is 30 seconds. This is the time the interface card waits after a power-up or reboot before starting to discover SCSI devices. This value should be set to no less than 250ms, according to the SCSI standard for Reset-to-Selection Time. This value may need to be increased to ensure that all SCSI devices complete their individual power-ups. With Discovery enabled, the Discovery Delay lengthens the time taken by the interface card to reboot.

•Select 5 to toggle the SCSI termination mode between Enabled and Disabled. This option is automatically set to Enabled for Internal termination. The Internal setting allows the interface card to internally terminate a SCSI connection. Setting this option to Disabled allows the SCSI bus, not the interface card, to handle SCSI terminations.

•Select 6 to access menu settings for the maximum SCSI bus connection speed, described later in this chapter. Note that when this option is selected, the user is prompted to select a Target ID on the currently selected bus. Currently, maximum speed settings are shown.

e1200-320 4Gb Fibre Channel Interface Card user and service guide 65