
Following are descriptions for each of the override settings:
NOTE: Normally, override settings should not be changed except when directed to do so by an authorized HP technician.
•Select 1 to toggle the
![]()
![]()
NOTE:
•Select 2 to toggle the Force FCP Response Code between OFF and ON for support of
•Select 3 to toggle the Initiator/Target Bit Setting in PRLI between INITIATOR Bit Set, TARGET Bit Set, INITIATOR & TARGET Bits Set, and INITIATOR & TARGET Bits CLEAR. This should be configured to one of the options for SET on both interface cards/routers when using the interface card in an interface
•Select 4 to toggle the Initiator/Target Bit Setting in PRLI_ACC between INITIATOR Bit Set, TARGET Bit Set, INITIATOR & TARGET Bits Set, and INITIATOR & TARGET Bits CLEAR. This should be configured to one of the options for SET on both interface card/routers when using the interface card in an interface
•Select 5 to toggle FC Confirm Setting in PRLI_ACC between FC CONFIRM SET and FC CONFIRM CLEAR. The default setting is FC CONFIRM SET. This option should be toggled to FC CONFIRM SET when the server is using QLogic HBAs.
•Select 6 to access the Target Reset Mode menu. The default setting is setting ALTERNATE. Following are descriptions for each of the settings:
•Select 1 to use a normal SCSI bus reset code to recover from a bus problem.
•Select 2 to uses a progressive SCSI bus recovery mechanism that first attempts to recover the bus by attempting a target reset and, if this fails, then trying the bus reset.
•Select 7 to toggle Force FLOGI in Private Loop between Disabled and Enabled. The default setting is Disabled. FLOGI Fabric Login is a process by which a node makes a logical connection to a fabric switch. This setting should be used to connect the attached Fibre Channel devices as private loop devices for certain switched fabric environments.
•Select A from the Fibre Channel Configuration menu to toggle the port speed between 1, 2, and 4 Gb/s for the selected FC port.